Xta-7000 Temperature Controller Manual !!hot!! Jun 2026

Proper wiring prevents electrical noise interference and ensures operator safety. Always disconnect the power source before starting the installation.

Indicates the Set Value (target temperature) or parameter values during programming.

If you see HHH on a PT100 sensor, unplug terminals 3,4,5. Use a multimeter to measure resistance between 4 and 5. A PT100 should read ~100 ohms at 0°C, ~138 ohms at 100°C. If infinite, the sensor is dead.

Connect your final control element (e.g., solid-state relay or contactor) to the output terminals. 3. Front Panel Layout and Navigation The front interface of the xta-7000 temperature controller manual

Press the key briefly once. The SV display digits will begin flashing.

The XTA-7000 features a multi-tiered menu system. Most setup procedures involve modifying the Target Set Value or running the Auto-Tuning cycle. Changing the Target Temperature (SV)

When your XTA-7000 stops working, the display shows a code. Here is the diagnostic table from the official manual: If you see HHH on a PT100 sensor, unplug terminals 3,4,5

The XTA-7000 includes several "hidden" or secondary functions for advanced configuration: Data Lock: Function/Hidden

Meaning: The displayed temperature changes drastically but does not match reality.

For the best results, use the Auto-tuning function to let the XTA-7000 calculate the ideal P, I, and D values for your specific environment: Navigate to the parameter. Change the value from oFF to on . If infinite, the sensor is dead

: Connect the positive wire to Terminal 9 and the negative wire to Terminal 10.

Setting a time segment to 0 will end the program at that step. XT -7000 TEMPERATURE CONTROLLER | Toolots

Shows the Set Value (target temperature) or parameter codes during configuration.