Hanmatek Dos1102 Manual Link Now

The most critical knob. Adjust it to sit within the waveform's vertical span to achieve a stable display.

: Includes Measure , Acquire , Utility , Cursor , and Save/Recall . 🔍 Initial Setup and Probe Calibration

The DOS1102 is designed for portability with a thin, lightweight body.

(the time difference, along with its equivalent frequency in Hz). 6. Advanced Triggering Basics

Choose your desired parameters from the on-screen menu. You can track critical metrics simultaneously, including: hanmatek dos1102 manual

Rotating clockwise reduces the volts/div (magnifies the signal), counter-clockwise increases it.

The oscilloscope waits for a single trigger event, captures the data, freezes the screen, and enters a "STOP" state. Use this to catch one-time transient events like power-up inrush currents or digital switch bounces. Data Export and PC Connectivity

According to official safety manuals for the DOS series , users must adhere to the following to prevent injury or equipment damage:

Connect the USB cable from the back of the DOS1102 to an open USB port on your PC. Turn on the oscilloscope. Open the PC software and select "Connect via USB." The most critical knob

Instantly sets the trigger level to the exact midpoint of the signal's peak-to-peak amplitude.

The interface is divided into several dedicated control areas for intuitive navigation:

Adjusts the vertical sensitivity (amplitude) of the signal. Menu (CH1/CH2): Opens the channel settings menu. Horizontal System Horizontal Position: Shifts the waveform left or right. Sec/Div: Adjusts the horizontal scale (time base). Trigger System

Set your probe switch to the position (recommended for most measurements). Connect the BNC end of the probe to CH1 . 🔍 Initial Setup and Probe Calibration The DOS1102

Do not attempt without reading the manual first. A failed firmware update can brick the device. The official manual provides the exact file naming convention and USB port to use (USB Host, not USB Device).

Set the cursor type to (horizontal lines) or Time (vertical lines). Use the multi-purpose knob to move Cursor 1 and Cursor 2. The screen will automatically display the difference ( ) between the two positions. 💾 Saving Data and Firmware Updates Exporting Screenshots Insert a FAT32-formatted USB drive into the front USB port. Press the Save/Recall button.

The DOS1102 balances performance with a slim form factor, making it ideal for workspaces with limited desk space. : 110 MHz.