Be careful not to file too deep; you want a uniform, round top. Step 4: Smoothing and Polishing
: Use fine-toothed blades (sizes 2/0, 1, or 3 are common) to minimize splintering and handle tight curves. Wood Selection : Use stable, thin hardwoods (1/8" to 1/4" thickness) like Baltic Birch plywood
This article covers the essential steps for leveling, crowning, and polishing frets.
You have now flattened the rounded tops of the frets. This creates a "flat spot" where the string contacts the fret, which causes intonation issues and a scratchy feel. We must fix this immediately.
The neck must be perfectly straight before you begin. If it has a bow or a back-bow, the leveling will be inaccurate. Use a notched straight edge (to clear the frets) to check straightness. If there is a gap under the middle of the straight edge, the neck has an up-bow (relief). If the straight edge rocks on a hump, the neck has a back-bow. Adjust the truss rod in small increments (typically ¼ turn at a time) to achieve a straight neck plane.
Hold the wood firmly down against the saw table to prevent vibration, chatter, and wood breakage. Step 6: Pattern Removal and Sanding
Baltic birch plywood, cherry, maple, walnut, and mahogany (1/8-inch to 1/4-inch thickness).
Be careful not to file too deep; you want a uniform, round top. Step 4: Smoothing and Polishing
: Use fine-toothed blades (sizes 2/0, 1, or 3 are common) to minimize splintering and handle tight curves. Wood Selection : Use stable, thin hardwoods (1/8" to 1/4" thickness) like Baltic Birch plywood fret work step-by-step pdf
This article covers the essential steps for leveling, crowning, and polishing frets. Be careful not to file too deep; you
You have now flattened the rounded tops of the frets. This creates a "flat spot" where the string contacts the fret, which causes intonation issues and a scratchy feel. We must fix this immediately. You have now flattened the rounded tops of the frets
The neck must be perfectly straight before you begin. If it has a bow or a back-bow, the leveling will be inaccurate. Use a notched straight edge (to clear the frets) to check straightness. If there is a gap under the middle of the straight edge, the neck has an up-bow (relief). If the straight edge rocks on a hump, the neck has a back-bow. Adjust the truss rod in small increments (typically ¼ turn at a time) to achieve a straight neck plane.
Hold the wood firmly down against the saw table to prevent vibration, chatter, and wood breakage. Step 6: Pattern Removal and Sanding
Baltic birch plywood, cherry, maple, walnut, and mahogany (1/8-inch to 1/4-inch thickness).
